Saturday, 19 December 2015

Computer Knowledge : Network MCQs Class Test Quiz 103


Computer Knowledge : Computer Network MCQs Class Test-II
IBPS IT Officer Exam Special Quiz

Q. 21. The interactive transmission of data within a time sharing system may be best suited to
a. simplex lines
b. half-duplex lines
c. full duplex lines
d. biflex-lines


Q.22. Which of the following statement is incorrect?
a. The difference between synchronous and asynchronous transmission is the clocking derived from the data in synchronous transmission.
b. Half duplex line is a communication line in which data can move in two directions, but not at the same time.
c. Teleprocessing combines telecommunications and DP techniques in online activities
d. Batch processing is the prefered processing mode for telecommunication operation.

Q.23. Which of hte following is considered a broad band communication channel?
a. coaxial cable
b. fiber optics cable
c. microwave circuits
d. all of above

Q.24. Which of the following is not a transmission medium?
a. telephone lines
b. coaxial cables
c. modem
d. microwave systems

Q.25. Which of the following does not allow multiple uses or devices to share one communication line?
a. doubleplexer
b. multiplexer
c. concentrator
d. controller

Q.26. Which of the following signal is not standard RS-232-C signal?
a. VDR
b. RTS
c. CTS
d. DSR

Q.27. Which of the following statement is incorrect?
a. Multiplexers are designed to accept data from several I/O devices and transmit a unified stream of data on one communication line
b. HDLC is a standard synchronous communication protocol.
c. RTS/CTS is the way the DTE indicates that it is ready to transmit data and the way the DCW indicates that it is ready to accept data
d. RTS/CTS is the way the terminal indicates ringing

Q.28. Which of the following is an advantage to using fiber optics data transmission?
a. resistance to data theft
b. fast data transmission rate
c. low noise level
d. all of above

Q.29. Which of the following is required to communicate between two computers?
a. communications software
b. protocol
c. communication hardware
d. all of above including access to transmission medium

Q.30. The transmission signal coding method of TI carrier is called
a. Bipolar
b. NRZ
c. Manchester
d. Binary


Q.31. A remote batch-processing operation in which data is solely input to a central computer would require
a. telegraphp line
b. simplex lines
c. mixed bad channel
d. all of above

Q.32. A band is always equivalent to
a. a byte
b. a bit
c. 100 bits
d. none of above

Q.33. The loss in signal power as light travels down the fiber is called
a. attenuation
b. progragation
c. scattering
d. interruption

Q.34. Avalanche photodiode receivers can detect bits of transmitted data by receiving
a. 100 photons
b. 200 photons
c. 2000 photons
d. 300 photons

Q.35. Communiction circuits that transmit data in both directions but not at the same time are operating in
a. a simplex mode
b. a half duplex mode
c. a full duplex mode
d. an asynchronous mode

Q.36. An example of a medium speed, switched communications service is
a. series 1000
b. data phone 50
c. DDD
d. All of the above

Q.37. In communication satellite, multiple repeaters are known as
a. detector
b. modulator
c. stations
d. transponders

Q.38. While transmitting odd-parity coded symbols, the number of zeros in each symbol is
a. odd
b. even
c. a and b both
d. unknown

Q.39. Data communications monitors available on the software marked include
a. ENVIRON/1
b. TOTAL
c. BPL
d. Telnet

Q.40. An example of an analog communication method is
a. laser beam
b. microwave
c. voice grade telephone line
d. all of the above


Read IBPS IT Officer Quest MCQs Quiz

No comments:

Post a Comment

Advertisement